[Yaesu] FT-1000 "D Question

Mon, 8 Sep 2003 22:13:25 +0200

Hello Neal,

Congratulations with your FT-1000D! I think this rig is still one of the
best transceivers ever made!

Alignment of the Transmitter Carrier Point:

Connect an AF signal generator to pin 8 of the MIC jack, and set the
transceiver to USB mode.

Set the MIC and RF PWR controls fully CW (maximum).

Adjust the AF injection frequency for maximum output power, and then adjust
the injection level for 80 Watts output.

Tune the AF generator to 360 Hz, and adjust TC4006 for 20 Watts output.

Now select the LSB mode, and adjust TC4007 for 20 Watts output.

Retune the AT generator to 2500 Hz, and confirm at least 20 Watts output in
both LSB and USB modes.

Good luck and enjoy your 1000D!

73, Hans Remeeus.
Ham Radio: PA1HR
www.remeeus.nl

Communication is about people, the rest is technology.

----- Original Message -----
From: "Neal Layman" <[email protected]>
To: <[email protected]>
Sent: Monday, September 08, 2003 3:09 AM
Subject: [Yaesu] FT-1000 "D Question

Just acquired an FT-1000D in super condition, early S/N 3xxx, Firmware 6.0.

Would like to find the carrier adjustment points - anyone have that info
close at hand?

Thanks in advance - 73 - Neal - N4XU   [email protected]

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---

Moderator: Ray Brown, KB�STN
_______________________________________________
Yaesu mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/yaesu