[Wswss] rotor bolt size

[Mike Goshay]

Thanks for the feedback to all. Seems my tap set is 1.00 pitch not 1.25 pitch required.Mike G w6we 

    On Wednesday, February 8, 2017 8:15 PM, Ralph & Marcy Berg. <k6tsk at juno.com> wrote:
 

 
They are 8mm.

73 Ralph



 
On Wed, 8 Feb 2017 22:10:36 -0500 <n6vi at socal.rr.com> writes:
> Mike,
> 
> It's in the manual.  I'm on the road this week but can look it up 
> when I get home if you haven't received an answer by then.
> 
> 73,
> 
> Marty N6VI/7
> West Yellowstone, MT
> 
> ---- Mike Goshay via Wswss <wswss at mailman.qth.net> wrote: 
> >  What is the correct size of the 4 top & 4 bottom bolts?I know 
> they are metric (Yasue GS1000 rotor).None of my metric taps are 
> fitting correctly.Do Not want to re-tap to SAE .
> Mike G w6we CM95805 929-1188H
> ______________________________________________________________
> Wswss mailing list
> Home: http://mailman.qth.net/mailman/listinfo/wswss
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Wswss at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> 
> ______________________________________________________________
> Wswss mailing list
> Home: http://mailman.qth.net/mailman/listinfo/wswss
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Wswss at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html