[Wswss] replacing Prop itch motor leads

[Mike Goshay]

Well I decided to take apart a PP rotor that I previously used (30 years).
Just to get a feel about what I need to do. 
It seems that once one removes the motor the connection points are on the
lower casing Held in place with a tiny clip retainer.
Remove it with a small tip screwdriver and the bakelite insulators lift
right out. You then can remove the contact sleeve by just pulling it and the
wire with follow. This connection is soldered and a stranded #10 AWG fits
perfectly in the solder hole. 
It is actually so simple it is hard to describe!!

Mike G w6we
Cm95ra
-----Original Message-----
From: wswss-bounces at mailman.qth.net [mailto:wswss-bounces at mailman.qth.net]
On Behalf Of Mike Goshay
Sent: Monday, September 03, 2012 10:44 AM
To: wswss
Subject: [Wswss] replacing Prop itch motor leads

After removing the motor how deep to I need to go to replace the motor wires
themselves.

It is in the tower beneath my eme array. Really do not want to take it
completely apart  unless I have no choices.

 

I have looked at the N7NV website but do not see details about replacing the
motor leads.

Mike G w6we

 

______________________________________________________________
Wswss mailing list
Home: http://mailman.qth.net/mailman/listinfo/wswss
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Wswss at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2197 / Virus Database: 2437/5246 - Release Date: 09/03/12