[Wswss] stuff for sale

[Tom Carney]

Posting for a friend, K9YC.  Jim currently lives near Santa Cruz. 
Contact him directly if interested.  k9yc at audiosystemsgroup.com

73,

Tom K6EU


IC746 (original) loaded with ICOM Auto Tuner, Inrad 500 Hz and 1.8 kHz 
filters in first IF, Icom filters in 455 kHz IF, TCXO, stock mic. In 
addition to being a nice HF rig, this is VERY nice on 6M and 2M, 100W 
out on all bands, internal preamp, internal keyer, four CW memories. 
Tuner works on 6M. Transmit audio can  be adjusted to be quite 
competitive. It was my primary 6M/2M radio in Chicago.
Looking for about $975 as loaded. I bought this in 2003 from a good 
friend who was the original owner. Power cable has Power Pole connector.

Yaesu 736R, all mode, 25W out on 2M and 432, has optional FTS8 PL board 
(XMIT and RX PL), and optional 600 Hz CW filter. Accepts plug-ins for 6M 
220 MHz, and 1.2 GHz. Stock mic.  This was a hamfest purchase from just 
before I left Chicago.  Something is intermittent and/or unstable, 
causing the radio to stop transmitting at higher power settings. Sold as 
is. Make offer.

Kenwood TS790A  2M and 432 All modes, 45W FM/CW, 35W SSB. Accepts 
plug-in for 1.2 GHz. Built-in XMIT PL, but needs option board for RX PL. 
Computer control jack  same as TS850, and I've used it with WriteLog. 
This is a very nice 2M/432 radio.  Looking for about $800.  Make offer. 
Power cable has Power Pole connector.

Timewave DSP599zx  Nice audio DSP unit for older radios that don't have 
their own built-in. I bought this used in 2003 to use with my Tentefc 
Omni V, and updated  the software soon after. I'm looking for the low 
$300 range. Make offer.

AEA MM3 Keyer  Very nice memory keyer, very programmable. I own two of 
them, also four MM1s. Make offer.

Bencher Paddle  This is the stock black one. I own about five of them, 
more than I need. Make offer.

HF Equipment:

Ten Tec 562 (Omni V.9), loaded with Ten Tec filters (CW filter in first 
IF), also added output keying line to work with Hercules I power amp. 
Very nice older  radio, 160-10M, NO internal tuner. Can sell with Shure 
444 mic, all filters,  computer interface cable (works with Writelog and 
most logging software). Power  cable has Power Pole connector. I'm 
looking for about $800 with all extras and  options. Make offer. 
Subtract $60 for each filter I leave out.

Ten Tec Hercules I (original), working fine, very clean. Includes 
interface cable and power supply. 500w out with 30-50w drive. Power 
supply tended to go into  protect mode after it had warmed up because 
voltage regulator wasn't very well temp-compensated and rose just enough 
to hit the protection circuitry. Fixed that by added a pair of Muffin 
fans to the power supply, mounting them in existing  grille work (no 
holes drilled). Amp is VERY clean, works very well. Needs a pre-
delay keying line (some radios, like FT-1000MP and Elecraft K3 have it 
already, others, like TS850, need to have it brought out to a connector. 
Also needs RX  antenna input in transceiver. The final transistors in 
this amp are unobtainable, so if they die it's a science project. Make 
offer. The power supply for this amp is far too heavy to ship. Pickup in 
Santa Cruz, or I'll drive and meet someone halfway.  :)

Inrad Roofing Filter mod for Omni V, VI, bought to use with Omni V.9, 
never installed, still in original packing.  This is the SSB bandwidth 
filter. Make offer.

LDG AT1000 high power tuner. Designed to work with 500-700w amps, but 
must be tuned with exciter power. Bought it new, never liked it, hardly 
ever used it.  It's virtually new. Make offer.

Terms of sale:  No Pay Pal. Cash, check or money order. Ship after check 
clears, ship to US only, sell rigs and amp to licensed ham only. Buyer 
pays my actual cost to FedEx or UPS. I pack myself, no markup.

73,

Jim