[WRL] LA-1 Selenium Rectifier Replacements

[john.brewer at us.schneider-electric.com]

I'm using my LA1 (successfully) with the Selenium rectifier. Is yours damaged?

John K5MO




                                                                                               
             Garey Barrell                                                                     
             <k4oah at mindspring.com>                                                            
             Sent by:                                                                       To 
             wrl-bounces at mailman.qth.n         "Walter S. Szachara" <szachara at gulftel.com>     
             et                                                                             cc 
                                               wrl at mailman.qth.net                             
                                                                                       Subject 
             05/02/2006 11:25 AM               Re: [WRL] LA-1 Selenium Rectifier Replacements  
                                                                                               
                                                                                               
                 Please respond to                                                             
               k4oah at mindspring.com                                                            
                                                                                               
                                                                                               




Walt -

When all else fails....  :-)

I just picked up the manual from BAMA.

Class C operation is at -13V, unregulated.  This is the 6.3V filament
voltage rectified with a selenium rectifier, and then loaded with two
220 ohm resistors in series (R4 & R7), with additional bias derived from
RF drive.  Class C bias isn't all that critical anyway, so just put a
1N4007 in place of SR-1.

For Class B, the bias voltage is specified as -3.2V.  There is a 3.3V
Zener, but low voltage zeners are sometimes a little hard to find.   I
would replace SR-2 through SR-4 with a string of five (5) 1N4007 diodes
in series.  The anode end of the string would go to ground, i.e., the
same as the selenium string.

73, Garey - K4OAH
Atlanta

Drake B & C-Line Service CDs
<http://www.k4oah.com>



Walter S. Szachara wrote:
> Good morning to all...
>
> I have a Globe LA-1 linear amplifier that I am trying to refurbish.  I am
> looking for suitable replacements for the for the 65 ma. 25V. selenium
> rectifiers used in the bias circuitry.  The voltage drop across the selenium
> rectifiers is important as it apparently generates the two bias voltage
> levels necessary for Class B or Class C operation.  The manual describes the
> theory as:
>
> "A regulated bias voltage is applied to the final tube grids for obtaining
> maximum linearity for Class B operation.  Class C operation is obtained by
> increasing the bias to the final grids...The bias voltage for Class B linear
> operation is regulated by heavy bleeding and the use of reverse-connected
> selenium rectifiers.  The back resistance of the rectifiers varies with
> applied drive and bias in such a manner that grid bias on the amplifiers is
> held to a very close tolerance.  The fixed bias voltage for the R.F.
> amplifier is obtained by rectifying the 6.3VAC filament voltage with a
> selenium rectifier."
>
> Does anyone on the list have any recommendations on suitable replacements
> for the stated selenium rectifiers?
>
> Thanks...
>
> Regards,
>
> Walt, W2OKF
>
>
> _______________________________________________
> WRL mailing list
> WRL at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/wrl
>
>
_______________________________________________
WRL mailing list
WRL at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/wrl

________________________________________________________________________
This email has been scanned for SPAM content and Viruses by the MessageL
abs Email Security System.
________________________________________________________________________