[W2CRA] ICOM IC-740 HF Transceiver & IC-AT100 AutoTuner For Sale

[John T McAuley]

I am selling a ICOM IC-740 Transceiver and ICOM AT-100 AutoTuner as
described below. I am asking $500 for the complete package. E-Mail me for
photos

73,

John

AB2XH

The ICOM IC-740 Features:

The IIC-740  transceiver covers 160 to 10 meters, i.e., 1.8-2, 3.5-4, 7-7.3,
10-10.5, 14-14.35, 21-21.45 and 28-29.7 MHz; [NOTE: the transceiver also
receives on 18.0-18.5MHz and 24.5-25.0MHz, but doesn't transmit on these two
bands. ] .Power is 200 watts input SSB/CW/RTTY modes. The 740 has
capabilities such as: dual digital VFOs, all-mode squelch,, notch, pass band
tuning, RIT/XIT, crystal calibrator and attenuator. You also get 9 memories.
Tuning increments are 1kHz/50Hz/10Hz. The florescent digital display is easy
to read. There is a cooling fan on the rear panel This radio requires 13.8
VDC at 20 amps, which is supplied by the built in AC power supply. And is
also capable of remote operation with a 12-15 volt/20 amp DC power supply
which is not part of this offering. There is a speaker built into the top
panel of the radio. This transceiver has the optional electronic keyer and
500 Hz narrow band,455KC, CW filter. installed. Included are an ICOM IC-HM7
microphone with built in preamp and an IC SM5 desk microphone.

 

IC- AT100 Features:

The  AT-100 is an automatic external antenna tuner for 80 through 10 meters,
frequency ranges are: 3.5-4, 7-7.3, 10-10.5, 14-14.5, 18-18.5, 21-21.5 and
28-30 MHz It provides auto band switching, Power capacity is 100 watts
continuous, 200 watts PEP. Minimum drive power is 8 watts. The top panel
access cover opens for adjustments for the Auto/Tune Preset switches, Preset
timers and Preset Indicators. The AT-100 features one input SO-239 jack and
four output SO-239 coaxial antenna jacks on the rear panel. Tune-up time is
typically 4 to 7 seconds. The power requirement is 13.8 VDC or 117 VAC which
is selectable from the rear panel. (241x111x300mm 5 kg). 

This unit has a built in AC power supply and supports remote operation with
a 12-15volt DC power supply which is not included. 

 

Instruction manuals and schematics for both the IC-740 & AT100 are included.
The unit is in good working order, has seen minimal use during the past 10
years due to family health issues and restrictive HOA regulations and has
been well cared for;  e-mail for pictures

 

 

 

John T McAuley