[Vintage-Audio] help with eico st-70 and equalizer connection

Wed Aug 21 14:11:01 2002

chuck, works like a charm. thanks very much.
now, mewonders why eico didn't label the ins/outs left and right instaed of 1
and 2. after i read your instructions, i looked again and sure enough, each
seperate input is labelled 1 and 2. seemed obvious after the fact (and
registered high on my "duhhhh" meter :-)
thanks very much,
denis

JM/CO wrote:

> Normally, an EQ unit would be connected in the tape loop in a home audio
> system. In your case, run "tape out" to the input of the EQ. The output of
> the EQ would be returned to the "Tape" jacks. Make sure that the "monitor"
> switch is in the correct position (monitor).
> Chuck N1LNH
> -----Original Message-----
> From: DA & M McCarthy <[email protected]>
> To: [email protected] <[email protected]>
> Date: Tuesday, August 20, 2002 2:22 PM
> Subject: [Vintage-Audio] help with eico st-70 and equalizer connection
>
> >hi guys. just completed my re-capping of the aforementioned amp, but
> >before i rip apart my new (he he) marantz 2235 (et al) set-up, was
> >wondering if anyone might tell me how to connect my s.s. equalizer to
> >the eico.
> >rear connections can be viewed at
> >http://www.flipperpie.com/eicost70rear.jpg
> >thanks in advance,
> >denis
> >
> >
> >
> >_______________________________________________
> >Home: http://mailman.qth.net/mailman/listinfo/vintage-audio
> >List Administrator: Duane Fischer, W8DBF
> >** For Assistance: [email protected] **
>
> _______________________________________________
> Home: http://mailman.qth.net/mailman/listinfo/vintage-audio
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: [email protected] **