[TMC] Mating 2-Pin Male Muting Relay Connector for GPR-90

[1oldlens1]

Isn't this a plain vanilla two pin line plug?  If so Ive gotten replacements for table lamps at Ace hardware stores.Are you  going to add an MSR to the GPR 90 ?Sent from my Galaxy
-------- Original message --------From: triodes at optonline.net Date: 12/7/22  3:44 PM  (GMT-08:00) To: tmc at mailman.qth.net Subject: [TMC] Mating 2-Pin Male Muting Relay Connector for GPR-90 I am finally properly integrating my GPR-90 into the shack, where it will be used in conjunction with my GPT-750 and SBK-1K clone transmitters.I am looking for the 2-pin non-polarized male plug that plugs into the female chassis-mounted connector marked "Relay", located on the rear apron of the GPR-90 receiver.I believe this was a standard 1950s-era connector made by Cinch, but I cannot find any vendor part number information, etc., for it.Does anyone have a spare they can sell to me? I want to use the correct physical interface between my external muting relay and the GPR-90, without any kind of hammy hambone kludge here.Any help here would be very much appreciated!Thanks & 73,Bruce, W2XR______________________________________________________________TMC mailing listHome: http://mailman.qth.net/mailman/listinfo/tmcHelp: http://mailman.qth.net/mmfaq.htmPost: mailto:TMC at mailman.qth.netThis list hosted by: http://www.qsl.netPlease help support this email list: http://www.qsl.net/donate.html