[TheForge] New knife steel

[CraigS]

I don’t contribute much here and haven’t  blacksmithed in a while.   Starting to make a move to central Oregon as I retire (Now 63) and will be setting up a new iron work area.  Which way should I point the anvil again??  KIDDING!!!
While everyone was paying attention to the list, I wanted to take a moment to thank all of you for the information I’ve gleaned over the years and years of just sitting quietly and reading this list and its predecessors.

Good wishes for the New Year,

Craig
Gresham, OR

From: Walter
Sent: Tuesday, December 28, 2021 10:34 AM
To: blcksmth via TheForge
Subject: Re: [TheForge] New knife steel

Bob,

I sure wish NOB and WRABA could get back together like we used to at 
Bill Hahns.

Walt

On 12/28/2021 12:07 PM, blcksmth via TheForge wrote:
>
> I tried Facebook over 10 years ago, but deleted my account 2 or 3 
> years later. I passed 81 a few months back.  Our blacksmith club, 
> Northwest Ohio Blacksmiths, started monthly meetings last Spring and 
> we are planning a weekend Hammer-In next May.
> Details will be on our website -  www.nob-blacksmiths.org     I still 
> demonstrate at the local county museum. Active is several hobbies. 
> Life is good!
>
> Bob
> WB8NQW
>
>
>