[TheForge] Kinyon Air Hammer

[jerry Frost]

Heh, heh, heh. I have lots of tools, parts and such because I can't remember
where I put the last one, what I DO remember is putting (it) somewhere I
can't lose it. <sigh>

Does it amaze you how little it takes to rebuild a cylinder? I see 2 Orings
and a gasket, not sure what the threaded fitting is; a logo maybe? I've
never had to replace fittings rebuilding a cylinder. I've replaced ones that
got damaged but not as part of a cylinder rebuild. I did mostly hydraulics,
our drill rigs carried a LOT of: fittings, cylinders, motors, pumps, valves,
etc. and being off road rigs they were always getting beat up. 

Congrats finding the easy solution Dave, going to buy a lottery ticket
today?

Frosty

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Dave Mudge
Sent: Tuesday, November 19, 2019 8:47 PM
To: Blacksmithing List Sponsored by ABANA
Subject: Re: [TheForge] Kinyon Air Hammer

Thanks for all of the input and suggestions. I was rooting through a file
cabinet draw marked "Air Stuff" and buried at the bottom in the back I found
this
https://www.facebook.com/photo.php?fbid=10218503319186486&set=p.102185033191
86486&type=3&theater

A genuine Parker Cylinder Repair Kit that I didn't even know I had.  What a
relief...
dave m