[TheForge] Little Giant / pulley / rpm / ???

[Dave Mudge]

Thanks Chuck, I'll check it out.
How is Buddy?

dave m

On Thu, Mar 19, 2015 at 6:20 PM, Chuck Robinson <robi5515 at bellsouth.net>
wrote:

> Hey Dave,
> Have you looked at the video "The power hammed cycle" by Dave Manzer of
> Wild Rose Forge?
> He shows you how to tune the hammer to make it hit harder and give you
> better control.
>  Fast speeds tend to wear parts faster while sacrificing control.
> ftp.anvilfire.com/bookrev/index.php?bodyName=*manzer*/.
> Chuck
>
>
> On 3/19/2015 12:57 PM, Dave Mudge wrote:
>
>> Well, lets expand on the original question.
>> Given I would want the end result to be about 375 rpm.
>> Also given that I have a 1725 rpm input (motor)
>> and the final drive is a 10" pulley, what size pulley
>> would I need to put on the motor?
>> Also,,, as one addresses the hammer from the front,
>> which direction should the crank plate turn? clockwise or
>> counter-clockwise?
>> thanks, everyone for all of your input...
>> dave m
>>
>>
>>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> http://www.avast.com
>
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.shutterfly.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>



-- 











NOTICE: Due to Presidential Executive Orders, the National Security Agency
may have read this email without warning, warrant, or notice. They may do
this without any judicial or legislative oversight. You have no recourse
nor protection.