[TheForge] Follow up on a kludged shoulder rivet to fit a keyhole slot

[Bruce .]

So curiosity got the better of me and I dug through my misc. hardware and
pulled out a short 1/8" steel pop rivet, and #6 flat and split washers that
fit the rivet.  I put the flat washer on first, then the split washer, then
riveted it into a 1/8" hole I drilled in an old coffee can.  Lo and behold,
it actually worked.

I didn't have a keyhole slot to try it in and didn't feel like going to the
trouble to make one, so I shoved the thing through a hole (slightly-larger
than the flat washer) in a sheet-metal fixture I had lying around.  The
coffee can hung onto the fixture about as well as could be expected.

I call that success.  I also call it cheap!

Bruce
NJ