[TheForge] TheForge Digest, Vol 124, Issue 8

[Bob Ehrenberger]

All the bits I have for my drill are only long enough to set anchors.

You might be able to chuck in a star drill if you have one the right sizel

Robert Ehrenberger
Shelbyville, Mo.
eforge at centurytel.net

----- Original 
Message ----- ----------------------------------------------------------------------

Message: 1
Date: Mon, 19 May 2014 11:37:09 -0400
From: Andrew Vida <osan at netlabs.net>
To: mspencer at tallships.ca, Blacksmithing List Sponsored by ABANA
<theforge at mailman.qth.net>
Subject: [TheForge] Hammer drill bits?
Message-ID: <537A2525.5000605 at netlabs.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Anyone here know of a good source for spline-shank hammer drill bits...
that or have one for sale?

I have to punch 7 holes through the footing of the house to fish some
3/4 rebar into so I can get the outer forms finished.  The hole under
the house is 10+ feet deep, is open to the outside, and it was COLD in
the house this winter past even with all the heat going. Don't want to
do that again, so need to get this deal done so we can get the new
foundation poured.

toolbarn.com had the lowest price, but almost 3 weeks to get the items
and they will not drop-ship.  Nobody else including Grainger has them in
stock, except a few and the difference is between $37 at toolbarn and
almost $90 elsewhere.

Any help would be greatly appreciated.  OBTW, the hammer is a Bosch.