[TheForge] Re: OT: Deep hole spot facing

[Mike Spencer]

Drill the 1/4" hole all the way through.

Get a piece of rod 1/4" OD (+0.001/-0.0).

Cut the configuration you want on the end of the rod.
Drill axial hole in rod as needed.

Shrink-fit, press-fit, silver-solder, braze, swage or otherwise fasten
rod into 1/4" hole.

-- 
Michael Spencer                  Nova Scotia, Canada       .~. 
                                                           /V\ 
mspencer at tallships.ca                                     /( )\
http://home.tallships.ca/mspencer/                        ^^-^^