[TheForge] Which Drill Rod?

[Peter Fels & Phoebe Palmer]

But the engineers who actually test and quantify the stuff disagree with our intuition Jerry.

On Nov 30, 2013, at 10:54 AM, Jerry Frost wrote:

Yes it would. Unless I'm seriously mistaken the heat treat would have an
effect as well. Quench a piece of O1 in water and try flexing it.

Frosty
-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Kim George
Sent: Saturday, November 30, 2013 6:21 AM
To: Blacksmithing List Sponsored by ABANA
Subject: Re: [TheForge] Which Drill Rod?

Wouldn't the deflection change depending on the width if the hub of the
pulley? If you have a pulley with a 3" hub on a 4' shaft wouldn't the
deflection be only over 1" of the shaft?

--
Kim George

"Why for you try to bury me in cold,cold ground?"
    Taz
______________________________________________________________
TheForge mailing list
Home: http://mailman.qth.net/mailman/listinfo/theforge
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TheForge at mailman.qth.net

TheForge mail list group photo site is
http://www.shutterfly.com
Login: blacksmithblacksmith at hotmail.com
Password: anvil

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
TheForge mailing list
Home: http://mailman.qth.net/mailman/listinfo/theforge
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TheForge at mailman.qth.net

TheForge mail list group photo site is
http://www.shutterfly.com
Login: blacksmithblacksmith at hotmail.com
Password: anvil

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html