[TheForge] (no subject)

[Dave Mudge]

Thanks for the information Allen.
I will change the address in the footer sometime over the weekend.
And thanks for being so stubborn.

dave mudge listmom for TheForge
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

On Fri, Feb 15, 2013 at 11:19 PM, <nicknaylo at aol.com> wrote:
>
> Date: Fri, 15 Feb 2013 19:59:25 -0500
> From: "Allen Dyer" <aldyer at lawlab.com>
> To: "Blacksmithing List Sponsored by ABANA" <theforge at mailman.qth.net>
> Subject: [TheForge] a round-a-bout trip to the forge photo area
>
> for getting to the photo area ---
>
> i just tried following the directions at the bottom of each message; i.e.
>
>    > TheForge mail list group photo site is
>    > http://www.photoworks.com
>    > Login: blacksmithblacksmith at hotmail.com
>    > Password: anvil
>
> and got the Shutterfly "Page unavailable" message page.
>
> BUT...being more stubbon than the average blacksmith (and that's sayin a
> lot!) i looked at the top right of the "Page unavailable" page and noticed
> a
> small "Sign In" box directly underneath "Wedding Paper Divas".  so, i
> clicked on the "Sign In" box and then input the login email address of
> "blacksmithblacksmith at hotmail.com" and then entered the "anvil" password,
> and, once again, received the "Page unavailable" message.
>
> at this point, i simply ignored the "Page unavailable" message (i did say
> "stubbon" didn't i?) and clicked on the "My Shutterfly" in the menu just
> above the "Page unavailable" message and i was taken to the page that has
> the photo of the forge shop in the USS Prometheus.
>
> SHORTCUT -- based on the above experience, i decided to start over and
> substitute "http://www.shutterfly.com" for "http://www.photoworks.com" in
> the boilerplate message at the end of each forge message, entered the
> login:
> "blacksmithblacksmith at hotmail.com" and password: "anvil" and i was
> immediately taken to the USS Prometheus.
>
> i respectfully suggest the forge end of message boilerplate instruction be
> changed from "http://www.photoworks.com" to "http://www.shutterfly.com".
>
> strike while the iron is hot,
> allen dyer
>
> Yup, it works now. Just uploaded some pics of the most recent piece of
> tooling to come out of my little forge. Hardy block for the anvil. 1 x 1.25
> forged to fit a 7/8 hardy. Tried working 1.5 x 2 stock recently, that didn't
> go so well.
>
> Michael S
>
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.photoworks.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html