[TheForge] Clutch lining material for a 50lb Little Giant

[Jerry Frost]

Good grief Charles, that's just entirely TOO EASY! Suggestions like that 
take a lot of the fun out of fixing this stuff. I mean seriously, just buy 
the right replacement instead of spending loads of time and effort 
re-inventing a thing?

In all seriousness, THANK YOU Charles!

Jer
----- Original Message ----- 
From: "Charles" <xlch58 at swbell.net>
To: "Blacksmithing List Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Monday, September 24, 2012 7:59 AM
Subject: Re: [TheForge] Clutch lining material for a 50lb Little Giant


>I would expect it to be standard industry clutch lining.   Here is the 
>McMaster
> Carr catalog entry.   They sell it in 6" wide strips.
>
>
> http://www.mcmaster.com/#catalog/118/3511/=jfkt60
>
> Charles
>
>
>
>
> ________________________________
> From: Dr. Stephen A Bloom <sabloom at ironflower.com>
>
> It's more like a conveyor belt material without the rubber. It gets
> contact glued to the clutch surface and then bolted in place. I'm not
> even sure who would likely stock that type of material.  ml
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.photoworks.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2012.0.2221 / Virus Database: 2441/5289 - Release Date: 09/24/12
>