[TheForge] OT Looking For Tool

[ries]

Muffler shops can flare tubing- but they do it with a $4,000 machine, where dies for each size of tube cost a few hundred bucks.
Works great, but I doubt its what the original questioner was searching for.


ries



On Jun 29, 2011, at 11:16 AM, <Grover.Richardson at gtri.gatech.edu> wrote:

Triumph motorcycle exhaust pipes have a similar flare.  At least the old ones do.  1967. A custom pipe place may have one or know where one may be had.  


-----Original Message-----
From: theforge-bounces at mailman.qth.net [mailto:theforge-bounces at mailman.qth.net] On Behalf Of Paul Sperbeck
Sent: Wednesday, June 29, 2011 1:56 PM
To: theforge at mailman.qth.net
Subject: Re: [TheForge] OT Looking For Tool

hi ries

the tools that we were referring to put a 90 degree flange on the end of 
a brass tube for connection to a sink strainer.
see:

http://www.acetogo.com/product/sink-tailpiece-15x12.html

Sure wish I could find a picture of the set.
Those strainers are commonly 1-1/2" or 2" the latter size mainly is used 
on commercial sinks and restaurant equipment. The 2" size was not 
stocked too much, so it was common to order a 3 foot length of brass 
tube and make the tailpieces as needed... labor was cheaper when I was 
an apprentice in the late sixties..

paul

On 06/29/2011 10:38 AM, ries wrote:
> It has been a REALLY long time since these were in common use- and they were not for "pipe"- they were for brass tube.
> You can still get em for smaller diameter brass and copper tubing- Ridgid makes a nice one that goes up to 1".
> Above that, they sell pound in mandrels that flange thin wall tubing.
> http://www.ridgid.com/catalog/RT2004-076.pdf
> 
> I dont think hand tools to flare inch and a half or two inch are still available, but there may be an industrial plumbing tool supplier that still makes em- if so, expect them to cost several hundred dollars.
> 
> ries
> 
> 
<< snip>>
______________________________________________________________
TheForge mailing list
Home: http://mailman.qth.net/mailman/listinfo/theforge
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TheForge at mailman.qth.net

TheForge mail list group photo site is
http://www.photoworks.com
Login: blacksmithblacksmith at hotmail.com
Password: anvil

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
TheForge mailing list
Home: http://mailman.qth.net/mailman/listinfo/theforge
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TheForge at mailman.qth.net

TheForge mail list group photo site is
http://www.photoworks.com
Login: blacksmithblacksmith at hotmail.com
Password: anvil

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Ries Niemi
Industrial Artist
http://www.riesniemi.com/