[TheForge] IR emissivity?

[peter fels]

On Jun 5, 2011, at 12:49 PM, peter fels wrote:

> Alternately;
> split the top of the square tubing at the corners with a hacksaw and hammer the sides out flat to fit the bottom of the drum. Drill or punch holes to fit the stud holes,  or studs in the drum.
> Use clay mud to seal the gaps.
> 
> On Jun 5, 2011, at 9:17 AM, Matt Gallagher wrote:
> 
>> I want to make a brake drum forge, and i have a pre made duck pot, its  2"
>> square tubing, welded into a hollow tee. I want to use a brake drum as the
>> firepot, but I cant think of any way to affix the tubing to the drum seeing
>> as how the tubing is square and the drum has a round hole. any ideas?
>> 
>> -- 
>> ~Matt Gallagher, your friendly teenage blacksmith
>> ______________________________________________________________
>> TheForge mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/theforge
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:TheForge at mailman.qth.net
>> 
>> TheForge mail list group photo site is
>> http://www.photoworks.com
>> Login: blacksmithblacksmith at hotmail.com
>> Password: anvil
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> 
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
> 
> TheForge mail list group photo site is
> http://www.photoworks.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html