[TheForge] OT - wood stove catalytic combustors, heat extractors, etc. (was: Barrel Stove Kits)
Bruce Freeman
freemab222 at gmail.com
Tue Oct 12 10:47:07 EDT 2010
I just looked up "Magic Heat" and it's described as a heat exchanger
only (with thermostated fan). OTOH, there are Condar's catalytic
combustors which actually burn the gases, but wear out after 10000
hours or so, they say. And I don't know whether they can be installed
in a flue pipe, or whether some special stove is needed for them.
Does anyone out there use these things? What luck have you had? How
do they install? How often must they be replaced? Do they reduce the
need for chimney cleaning (with brush)?
I probably will not be using my wood stove all that much anyway, so my
inclination is to do without. From two test burns I find the smoke
quits when the thing heats up anyway.
On Tue, Oct 12, 2010 at 10:12 AM, CGRAF <adveniam at att.net> wrote:
> On 10/11/2010 10:38 PM, Andrew Vida wrote:
>>
>>
>> JAMES OESTREICH wrote:
>>> Paul N wrote:
>>
>>> Have one in my shop got it at menards 4 or 5 years ago with a majick
>>> heat in the stack
>>
>> THose things draw a LOT of the waste heat out of the gases. But as
>> Jerry will no doubt point out, you don't want your smoke going too cold,
>> lest ye set thyself up for a raging stack fire one day.
>> ______________________________________________________________
>>
>
> The ones that I have seen had secondary combustion of all those
> vaporized volatiles and soot. Done properly the creosote gets burned and
> the flue products are clean.
>
> Solid fuel on the bottom essentially a gas burner on top.
>
> The ones that have all the tubes in the secondary are mostly just heat
> extractor setups.
> These are two very different animals.
>
> Mike Graf
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.photoaccess.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
--
Bruce
NJ
More information about the TheForge
mailing list