[TheForge] Forge rails

[PlumDon at aol.com]

In a message dated 7/7/2010 2:14:59 P.M. Eastern Daylight Time,  
akfrosty at mtaonline.net writes:

In those  
cases the forges were sitting on a table-like surface. If you have your  
forge on a table I'd make a small stand with a top at the level of the  
door 
bottom.
Thank you Frosty, et al. Now that seems such an obvious solution.  
'Specially since I keep it on a rolling metal table. What was so irritating  about 
this business is that I didn't think of it. I'm concerned now that it was  
because I was old or stupid.