[TheForge] Forge rails

[Ron Childers]

Could you build a cradle and brace to set it on so the weight of the forge
holds it in place?

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of PlumDon at aol.com
Sent: Tuesday, July 06, 2010 2:02 PM
To: theforge at mailman.qth.net
Subject: [TheForge] Forge rails


After 22 years I finally bought a new  Whisper Daddy from NC. I had patched 
and welded and re-lined and replaced the  old one so much it was hardly 
recognizable. I would like to put some kind of  sliding support rails
similar 
to what I had welded on my old forge. But I hate  to weld through the new 
shiny finish. Anyone have any suggestions for some kind  of attached brace
to 
hold stock in front while heating that does not require  welding.

Thanks for any ideas

Don Plummer  

______________________________________________________________
TheForge mailing list
Home: http://mailman.qth.net/mailman/listinfo/theforge
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TheForge at mailman.qth.net

TheForge mail list group photo site is
http://www.photoaccess.com
Login: blacksmithblacksmith at hotmail.com
Password: anvil

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

 
 
****************************************************************************
********
This footnote confirms that this email message has been scanned by
PineApp Mail-SeCure for the presence of malicious code, vandals & computer
viruses.
****************************************************************************
********





 
 
************************************************************************************
This footnote confirms that this email message has been scanned by
PineApp Mail-SeCure for the presence of malicious code, vandals & computer viruses.
************************************************************************************