[TheForge] Power Hammers

[peter fels & phoebe palmer]

Similar story on a number of  the early Anyangs from China.
If the US rep didn't have a lot of backing, it'd make little difference.
It might be argued that they were cheaper than a worn out Chambersburg 
and both needed rebuilding..sigh.

On 12/19/2010 3:22 PM, Bob Ehrenberger wrote:
> If they had a US rep it might be worth a shot, but I see nothing but trouble
> working directly with a company in China.
>
> I have one of the hammers that Tom Clark got from Pakistan, it looks a lot
> like these.  The basic design was good but they did a real poor job with the
> finishing. It took me a couple months work to get it running right. Needless
> to say Tom only got one shipment from that supplier, and then dropped them.
> I was expecting to just build a base and mount a single phase motor, ended
> up tareing it down to the bare casting and working my way through it. It's
> been running for two years trouble free.
>
> Robert Ehrenberger
> Shelbyville, Mo.
> eforge at centurytel.net
>
>   On 12/19/10 12:54 AM, peter fels&   phoebe palmer wrote:
>>> Different kinda chinese self contained PH?
>>>
>>> http://www.alibaba.com/product-gs/383869539/Air_Hammer_C41_Series.html
>>>
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.photoworks.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>