[TheForge] bandsaw steel problem

[Andy Gladish]

Very cool!
Like most good ideas it's obvious once you know about it ;-)

--------------------------------------------------
From: "Geoff" <gjn.pub at gmail.com>
Sent: Wednesday, April 07, 2010 4:51 AM
To: "Blacksmithing List Sponsored by ABANA" <theforge at mailman.qth.net>
Subject: Re: [TheForge] bandsaw steel problem

> Quench between two pieces of steel or aluminium or copper plate. To be
> more explicit you heat your band saw steel to non magnetic then put it
> on one plate and very quickly place the other plate on top. The plate
> pulls the heat quickly enough to harden at the same time prevent warping.
>
> Geoff
>
> Andy Gladish wrote:
>> Thanks for all the thoughts and suggestions...now to try to get it to 
>> harden
>> without turning into a potato chip!
>>
>> ______________________________________________________________
>> TheForge mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/theforge
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:TheForge at mailman.qth.net
>>
>> TheForge mail list group photo site is
>> http://www.photoaccess.com
>> Login: blacksmithblacksmith at hotmail.com
>> Password: anvil
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>>
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.photoaccess.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html