[TheForge] Crow bar help

[PlumDon at aol.com]

In a message dated 11/22/2009 10:45:03 P.M. Eastern Standard Time,  
williamsiron at comcast.net writes:


A customer dropped off two fairly  large crowbars needing one end, the pry 
bar, hammered out to remove chips. The  hammering part is no problem, 
however, what kind of heat treatment would you  recommend? 
 
 

Serious liability opportunity here, Mark. Picture him 20' up on a roof  
ripping out rafters and the overly hardened tip snaps. I would not heat treat 
at  all.

Don