[TheForge] shop floors

[wmullett at bright.net]

Terry, I think just a sealer would be fine.  

Epoxy is expensive and you don't need it.  We use that in must clean areas and very high use.  We don't have that need in a normal shop.  

Should you be concerned about non-slip?  Maybe.  If you get a steel troweled finish, it might get slick when wet.  If they over-work a surface or work it late, they can work all the cream to the surface which will then chalk and possibly spall over time.

A broom finish is what you would use on a sidewalk, but that has a lot of ridges and valleys in it that will fill with dirt and be hard to clean ... if you care.  

Maybe just a float finish would be ok if you don't want a really smooth surface.  

Ask your contractor to show you some examples so you can do what's best for you but I still think epoxy is pouring your money on the floor.

---- Original message ----
>Date: Fri, 15 May 2009 12:04:23 -0500 (CDT)
>From: theforge-bounces at mailman.qth.net (on behalf of "terry l. ridder" <terrylr at blauedonau.com>)
>Subject: [TheForge] shop floors  
>To: theforge e-mail list <theforge at mailman.qth.net>
>
>hello;
>
>with concrete floor in the new shop i have been thinking that perhaps
>the concrete surface should be covered with expoxy non-skid paint. i
>have looked at the various covering offers from quickrete. i am curious
>as to what others have done with their concrete floors.
>
>-- 
>terry l. ridder ><>
>______________________________________________________________
>TheForge mailing list
>Home: http://mailman.qth.net/mailman/listinfo/theforge
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:TheForge at mailman.qth.net
>
>TheForge mail list group photo site is
>http://www.photoaccess.com
>Login: blacksmithblacksmith at hotmail.com
>Password: anvil
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html