[TheForge] Forging a post vice

[Larry Brown]

Re did site, fractions should load correctly for those who had problems;
http://www.lightningforge.com/upload61/vise.htm


The link to Tim Suters article is on the NJBA home page or use;

http://njba.abana-chapter.com/timvise.htm

Let me know of any problems
Larry




>Larry-
>That file comes through with a lot of unknown characters.  Some of
>those appear to be fractions.  Any chance you could let folks know
>what those mean.
>Also, maybe you could provide a link to the vise-rebuilding article
>Tim Suter wrote a few years ago.
>
>All-
>Tim Suter took apart and repaired an old vise and IIRC found that the
>box threads were not lathe-cut but were a separate coil of square
>stock, brazed in place.  I did not see this myself.