[TheForge] Forging a post vice

[Larry Brown]

This should do it;
http://www.lightningforge.com/upload61/vise.htm


At 08:54 AM 4/22/2009 +0100, you wrote:
>Well I'm interested even if no-one else is!
>
>Rich M.
>
>Richard Maynard - Artist Blacksmith
>The Forge, Much Hadham, Hertfordshire SG10 6BS
>
>The Forge Experience - be a blacksmith for a day!
>http://www.muchhadhamforge.co.uk/experience.pdf
>
>rich at muchhadhamforge.co.uk
>www.muchhadhamforge.co.uk
>
>
>-----Original Message-----
>From: theforge-bounces at mailman.qth.net
>[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Larry Brown
>Sent: 22 April 2009 02:01
>To: Blacksmithing List Sponsored by ABANA
>Subject: Re: [TheForge] Forging a post vice
>
>
>
>
>I was just inadvertently send the plans by a Forge member and I realized I
>published them In the NJBA newsletter (A long time ago, volume 6 and I'm up
>to 14 now). If there is any interest I'll post them and send the URL Larry
>Brown
>
>
>At 01:37 PM 4/21/2009 -0700, you wrote:
> >There was a series of articles in the Anvil's Ring on restoring a
> >postvise a while back.
> >
> >Ben Barrett wrote:
> > > Hurm, I seem to remember something like that too, but I also cannot
> > find it.
> > > This might be a good ref though:
> > > http://www.anvilfire.com/FAQs/vises.htm
> > >
> > > Ben
> > >
> > >
> > > On Tue, Apr 21, 2009 at 5:00 AM, Ron Childers <munlaw2 at hcsmail.com>
> > > wrote:
> > >
> > >> A friend of mine thinks he wants to forge a post vice. There was an
> > article
> > >> in a publication or maybe on the internet about making a post vice
> > >> that I skimmed through it but don't remember the source. Does
> > >> anyone know where I might have seen that article?
> > >>
> > >> Thanx,
> > >>
> > >> Ron C