[TheForge] low carbon sheet

[Peter Fels & Phoebe Palmer]

Jim;
Look for deep draw sheet if you can find it. Otherwise, i read that the 
sheet they used to enamel for stove sides is pretty close.
The sheet they use to make laminated motor cores, transformers and 
electromagnets ought to be good, but i don't know where to get smaller 
amounts...pf

jim poulmas wrote:
> Anyone know where I can get my hands on some UNIVIT sheet metal? It's
> great for leaf work because of its low carbon content. (.003%) It's
> basically wrought iron sheet. I was told that if I couldn't find any
> the next best thing was to cut up a 50 gallon drum but I'm not sure
> what the carbon properties are on those. Looking for 22 gauge.
> Thanks
> Jim Poulmas
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
>