[TheForge] Printers lead

[dan tull]

Although, "black powder shooters" could be paper patched bullet shooters.


----- Original Message ----- 
From: "Grant Marcoux" <gblacksmith at alamedanet.net>
To: "Blacksmithing List Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Sunday, September 07, 2008 6:26 PM
Subject: RE: [TheForge] Printers lead


> Lynn:  Your alloy is great for bullets and possibly for babbit bearings. 
> It
> is MUCH tougher than pure lead.  Perhaps you could find a caster that 
> would
> swap you some pure lead for some alloy.  Try bullet casters, esp. black
> powder shooters.  Grant
>
> -----Original Message-----
> From: theforge-bounces at mailman.qth.net
> [mailto:theforge-bounces at mailman.qth.net]On Behalf Of Lynn and Susan Lang
> Sent: Sunday, September 07, 2008 8:19 AM
> To: theforge at mailman.qth.net
> Subject: [TheForge] Printers lead
>
>
> Hello
> I have acquired a quantity of printers lead, ingots that were used in a
> Mergenthaler linotype.  The proportions are Lead 85 percent, Antimony 11
> percent and Tin 4 percent. Is this suitable for Repousse backing
> material?
>
> Thank you
> lynn
>
>
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 270.6.18/1658 - Release Date: 9/7/2008
> 3:30 PM
>
> No virus found in this outgoing message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 270.6.18/1658 - Release Date: 9/7/2008
> 3:30 PM
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>