[TheForge] power hammer FS in AL

[Ben Barrett]

Howdy folks, another internet find:
http://www.bladeforums.com/forums/showthread.php?p=5236026%23post5236026
main text from link:
"Bradley 125lb. guided ram helve, built for Industrial use, very good
original condition with original 6hp 3 ph motor. Hammer has very good
bearings, can turn over the drive weel with 1 hand. Has combination
dies in good shape with 1 small repairable chip on 1 corner. Hammer
hasnt been monkeyed with or abused etc.

Ready to be wired up & put to use. All it needs is a foot treadle,
switch wired, and drive belt, all are cheap/easy fixes. These Bradleys
were not "farm"" or "blacksmith" hammers, but Industrial hammers meant
to be used 24/7/365, hard. I have replaced the missing guide ram bolt
& the one that has the bent head in the photo, with original Bradley
bolts from Cortland Machine.

$3000 FOB as is, for $3500 I will fabricate treadle, have switch
wired, and put on a new drive belt. Would also consider trading for
75-150 Fairbanks, Beaudry, Bradley Compact etc.

email/call for further info. lameyknives at aol.com 901 288 9172"

follow link for pictures and discussion

cheerio,

Ben