[TheForge] MIG Welders

[Larry Brown]

C25 = Argon/CO2 mix for the gas.
I would heat the thicker sections up a bit with a torch to help the MIG 
penetrate better and more evenly.
L Brown

At 09:54 AM 5/22/2007 -0400, you wrote:
>1/2" plate is the thickest welds that I will have. Not going to buy a
>stick welder just for this. Will do multiple passes I guess....But the
>gas addition was needed I know that and have been meaning to do it, just
>didn't have the need like I do now. Just a matter of getting aquainted
>with the new set up...
>
>Thanks
>Mark
>
>
>
>half inch plate?? multiple pass with a gas mixed with a smaill about of
>oxygen so you can spray it on ....OR stick weld it
>
>_______________________________________________
>Manage membership or unsubscribe at:
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith at hotmail.com
>password:  anvil
>___________