[TheForge] Coal Forges - lets try this again

[Andy Gladish]

That's what I did oh, about five years ago- 3/8 for the pot and 1/4 for the
table. In use, it always has a layer of ashes in it anyway, so it doesn't
get very hot- should last on and on.
Really, so easy to fabricate, and you can just weld pipe on the bottom for
draft and ash dump.

Andy G.



John wrote:
Hell, seems to me 1/8-inch is plenty if you weld a couple of 1-1/4 X 1-1/4 X
1/8 angles under it for stiffeners. Something like bedframe angle would
work.

You're just going to be holding up some coal and maybe a few pairs of tongs,
no?