[TheForge] Coal Forges - lets try this again

[Jerry Smith]

Ben,

For the table I was thinking of 1/4 or 3/8 inch. The
fire pot is a different story, if I made it, I would
use 1/2 inch, but that I may buy.

Jerry

--- Ben Barrett <stircrazyben at gmail.com> wrote:

> Sorry there, 1/8" can work for the table, but I'm
> sure you will want
> more thickness in the firepot.
> 
> ben
> 
> 
> On 7/2/07, Ben Barrett <stircrazyben at gmail.com>
> wrote:
> > You'll want something heavy enough to take a
> poking or three, if
> > you're going the DIY/scrapper route you could
> prolly find some thick
> > drain-grate or something to suffice.  I've also
> been hearing that
> ...
> > ads on craigslist, you just gotta ask if you want 
> something.  1/8"        <--
> > thick or greater should do the job, and not burn
> up [much at all] as
> > the fire is usually raised up a bit on a bed of
> coal/ash, another nice
> > feature of the side draft.
> ...
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
>