[TheForge] wire brush

[Roger R Degner]

When I taped Bill Epps at BAM he said to use an electric buffer which is
slower RPM which doesn't throw wires as bad

Roger R Degner




Wonderful Tool -- Most Dangerous Tool in my shop.  Pay attention to 
everything Larry has said.  I always use my grinder with a wire brush
two 
handed -- this helps a lot.  Put the item you are going to clean up in
the 
vise -- unless it is something really big like a steel fabrication.
Since I 
have more than one angle grinder I keep my wire cup brush on the weakest

one -- the one with the smallest motor -- still plenty of power for this

use.  As I said at the start a very useful tool -- just be careful
getting 
to know it -- and above all you must have eye protection !!