[TheForge] More Drill Press stuff

[Phil]

that sounds kind fast to me.  I think my low speed is
62 rpm's.

--- Woolley <wjec at verizon.net> wrote:

> Hello,
> 
> I 6sm at comcast.netdropped in on a local machinist I
> know who is winding 
> down to see if he was ready to sell any of his
> drilling machines. Last 
> time I asked he wasn't. Anyway he has a two spindle
> Rockwell setup with 
> an unslotted table, single phase, working, with
> Jacobs chucks, probably 
> around a 1960 or so vintage that is unused ,both
> motors power up etc. 
> Nice. The machines are belt drive multispeed down to
> 330/500 depending 
> on the RPM of the motor (which I couldn't see).  The
> HP of the motors 
> are 3/4.  My question, does anyone know the capacity
> of the machines 
> based on this info.  5/8, 3/4 holes? He wanted me to
> make an offer, 
> ("what will you give me for that Rockwell"?) but I
> left it  up to him to 
> come up with a price. Any help appreciated.
> 
> Regards,
> Bill Woolley
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 



      ____________________________________________________________________________________
Looking for last minute shopping deals?  
Find them fast with Yahoo! Search.  http://tools.search.yahoo.com/newsearch/category.php?category=shopping