[TheForge] Re: Sheet metal bender

[Daniel Kretchmar]

Thanks Kenny.  I have been convinced to use the galvanzied duct.  I already 
placed an order for it at Menards.  It's fairly cheap and will save alot of 
time.

Dan


----- Original Message ----- 
From: "Kenny O." <phat at cavenet.com>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Saturday, September 23, 2006 7:22 PM
Subject: Re: [TheForge] Re: Sheet metal bender


> GHS wrote:
>
>> Mike Spencer wrote:
>>
>>>> Mike, I'll likely weld it instead of a lock seam, though I would
>>>> like to know what that is...picture?
>>>>
>>>
>>>
>>>   http://home.tallships.ca/mspencer/lockseam.html
>>>
>>> - Mike
>>
> I used to work a little sheet metal so I have a few books on layout. One 
> in particular has great geometrical construction and isometric views for 
> very easy production.
> The book :
> Short Cuts for Round Layouts
>
> I could copy a particular problem and post it somewhere if you had one in 
> mind .
> If you would like to know anything more about topics presented in the book 
> let me know.
> Kenny O
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>