[TheForge] Sheet metal bender

[Bob Willman]

	Where are you located? We got a 12' X 12" dia stainless stack for
the Wood County Museum forge for about $60. 


Bob Willman
Bowling Green, Ohio
The Eagle's Anvil
WB8NQW

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Daniel Kretchmar
Sent: Monday, September 18, 2006 11:18 PM
To: Daniel Kretchmar; Sponsored by ABANA
Subject: [TheForge] Sheet metal bender

Greetings,
           I need 12" diameter chimmey pipe for my new side draft hood.  I
looked into menards.  They have galvanized 12"  24 gauge chimney.  I looked
into having some custom stuff made but it's too costly.....so the next
question is.....can I make it myself?

What kind of bender would I need to make 12" diameter pipe/tubing out of 24
gauge stainless steel?  I want to make it in 2 ft sections. which means
investing in a crimper a bender.....and what about elbows?  I'll need two 90
degree elbows.  How will I make them?

Advice is appreciated

Dan 


_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________