[TheForge] Lighting your forge on purpose.

[dan at irontreeworks.com]

I start some charcoal in the middle with kerosene or lighter fluid using a
lighter. Kerosene doesn't go boom like gasoline.   Once it is lit, I crank the
blower a bit and then push the coal toward the center. viola

Dan

 and Quoting Jerry Frost <frosty at customcpu.com>:

> It's been quite a while since a thread about lighting
> your coal forge ran on the list. I'll kick it off with
> my favorite method.
>
> I cut or tear a strip of cardboard about 1 1/2-2" wide
> a foot or so long and roll it tightly. Then I place it
> over the center of my air grate and allow it to spring
> open a little. Ideally the gaps and cardboard are about
> the same. I make a crater shaped mound of coal around
> the coil to hold it in place then pile smallish chunks
> on the coil. These need to be coarse enough air can
> pass through them but I pile fines on the outside of
> the mound to contain the air.
>
> Once I have it laid I drop 2-3 lit wooden matches into
> the coil while giving it a real gentle blast, just
> enough to keep the matches going but not blow them out.
> This is, believe it or not, the trickiest part of the
> whole process and a few drops of lighter fluid (scout
> water <grin>) are an easy cure. As the cardboard coil
> starts to burn I cover it completely in coarse 3/4" +/-
> coal and increase the blast. Once the coal starts to
> take I cover it with fines and give it the air.
>
> It takes longer to describe the technique than it takes
> to start the fire.
>
> To get the fire ready for forging is a different matter
> of course and depends entirely on personal preference
> and what you're going to be doing.
>
> My like to coke up the day's coal in the morning rather
> than have the smoke and flame with me all day.
>
> Frosty
> -------------------------------
> If it ain't forged
> it ain't real.
> Wrought iron is.
> The FrostWorks
>
> Meadow Lakes, AK.
>
> http://www.artmetalradio.com/
>
> From: <dann at wctatel.net>
>
>
>
> >
> > Bob,
> >
> > Sounds fishy to me.  Wet coal, or dry coal, it is
> > takes both heat and air
> > to get it to burn.  That is the most frustrating part
> > of working a coal
> > forge.   My hats off to those who usually get the
> > forge fire started with
> > a single sheet of crumpled newspaper.  More than
> > once, I resorted to a
> > handful of match light brick-ets nested in forge
> > when I needed the coal
> > forge working without a big loss of time or
> > embarassment.
> >
> > Wet hay can spontaneously combust because it gets a
> > mold kind of reaction
> > going that eventually heats the and dries the core
> > enough to ignite.  I
> > wouldn't be surprised to learn that the mold decomp
> > process might even
> > produce some combustable gasses.
> >
> > With coal,  the cellulose -  to - carbon change
> > occured millions of years
> > ago.
> >
> > Dann
> >
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>




----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.