[TheForge] Re: Twister (Was:: housekeeping...)

[Woolley]

Larry,

You need to take a run down to Glassboro NJ to Fazzios to load up on what's 
unavailable to you in your area.  I'm surprised you can't get a section like 
that there.

Regards,
Bill Woolley

----- Original Message ----- 
From: "Larry Brown" <lp.brown at verizon.net>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Saturday, October 28, 2006 9:54 AM
Subject: Re: [TheForge] Re: Twister (Was:: housekeeping...)


> I'm in the NYC area, it figures I can't get it here. I think the shipping 
> would take the fun out of ordering it from your supplier ;-)
> LB
>
>
> At 09:14 PM 10/27/2006 -0500, you wrote:
>>not that it does you any good Larry but I can get 1/8"x1/2"x1/2" here in 
>>Minnesota.
>>
>>Bob
>>___
>>
>>
>>On Oct 27, 2006, at 6:08 PM, Larry Brown wrote:
>>
>>>Twisting multiple elements together will shorten in length, I.E. three or 
>>>four rounds or a mix of  squares, rounds, angles, etc. Did some nice 
>>>twists with 1/4 round 1/4 square and 1/8 x 1/2 angle. Can't get the angle 
>>>any more though
>>>L Brown
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>