[TheForge] Zinc Joining Advice

[Bob Ehrenberger]

Marsha,

BAM president Kirk Sullens organized a group buy of the valves last May. He
got a discount from his local Air Gas dealer by ordering 10 units. I think
our cost was $135, it paid for itself in no time.

Robert Ehrenberger
Shelbyville, Mo.
eforge at centurytel.net


----- Original Message ----- 
From: "Riverbend Blacksmiths" <riverbendblacksmiths at mac.com>
To: "Bob Ehrenberger" <eforge at centurytel.net>; "Sponsored by ABANA"
<theforge at mailman.qth.net>
Sent: Thursday, November 30, 2006 10:00 AM
Subject: Re: [TheForge] Zinc Joining Advice


Bob, where, if I may ask, did you get your Smith Gas Saver? Did you
purchase this recently? Still available?

Marsha.
---
On Nov 30, 2006, at 10:32 AM, Bob Ehrenberger wrote:

> Wayne,
> Another request for the pictures here...
>
> I have a Smith Gas Saver and really like it, it had instructions on
> getting
> rid of the POP but it doesn't bother me and it provides an audible
> conformation that it shut off.  If I'm bending or welding a lot of
> little
> pieces it really saves a lot of time not having to lite and adjust
> the torch
> each time.  I also installed the check valves at the base of the
> Gas Saver
> so I don't have to worry about back flow.
>
> Robert Ehrenberger
> Shelbyville, Mo.
> eforge at centurytel.net
>
>
> ---- Wayne Ackman <stryker at vulcanproductions.us> wrote:
>> I built one of the treadle torch setups John Crouchet uses in his
>> video.  great design that allows you to step on a peddle to fire the
>> torch and when you step off, the torch turns off.  The ultimate setup
>> for using a gas saver.  I have an email with pictures if anyone
>> wants it.
>>
>> Wayne
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>