[TheForge] Plate for my post vise

[martin paietta]

The scrap on it is 50 cents to a $1. I am guessing it is about 87 pounds. I
didn't want to waste the money on a test.

Not to sound like a jerk, but what does the way my anvil points have to do
with it?

Thanks
Martin

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Dan Tull
Sent: Tuesday, November 14, 2006 3:07 PM
To: Sponsored by ABANA
Subject: Re: [TheForge] Plate for my post vise

Now that depends.
Which way does your anvil point?
Why don't you try it and see if it meets your needs?




----- Original Message -----
From: "martin paietta" <mpaietta at iglide.net>
To: <theforge at mailman.qth.net>
Sent: Tuesday, November 14, 2006 6:03 PM
Subject: [TheForge] Plate for my post vise


I need a thicker plate for my 51/2" post vise. Currently I have a ¼" piece.
My friend found a ¾" piece that is 22x18. I want to make it round so I can
roll it. I was just going to weld the ¼" on to the ¾" for a total of 1".
Would a 1" piece that is 18" dia be heavy enough so it will not move all
around?



Thanks

Martin

_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________




_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________