[TheForge] Air hammer recommendations?

[robert hensarling]

Ron, which model do you have, and have you had to replace any parts (belt, 
etc) yet?
Robert

----- Original Message ----- 
From: "Ron Childers" <munlaw2 at hcsmail.com>
To: "'Sponsored by ABANA'" <theforge at mailman.qth.net>
Sent: Wednesday, May 17, 2006 9:52 AM
Subject: RE: [TheForge] Air hammer recommendations?


Roger, we have no regrets after 5 years of pounding in a production shop,
but as you know, the harder the hammer hits the sooner you will have to
dress the dies. Jeff finally got a new, more versatile set; wide on one side
and narrow on the other for drawing out square & round...

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Roger R Degner
Sent: Wednesday, May 17, 2006 10:18 AM
To: 'Sponsored by ABANA'
Subject: RE: [TheForge] Air hammer recommendations?

So what took so long to install problems or having fun hammering.
What size breaker was needed and what HP motor?
I plan to be at Tom's on memorial day picking up a 60
What dies did you get
Any regrets so far?
How about some pictures of the rocking chairs forgemagic.com lets you
post pictures.

Roger R Degner


> -----Original Message-----
> Ok.  Tom Clark and I installed my air hammer until 4 AM this morning,
>

_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________



_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________