[TheForge] Platen table.

[G. Watts]

Rob,
If it's cast iron (I'm guessing, since it broke off) you're going to have to
air arc it...unless you've got a really big bandsaw...
George.


-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net]On Behalf Of Robert J Hill
Sent: Thursday, May 11, 2006 6:03 PM
To: Sponsored by ABANA
Subject: [TheForge] Platen table.


I have another question regarding fixer upper tools.  I may have a
chance to get a platen table with roughly a third of it broken off, for
free.  Should I use Oxy/Acet to cut the jagged part off or an air arc
set up?  I've never used an air arc. When I do get it to a useable
state should the stand bring the table to anvil height?
Thanks again,
Rob Hill

_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________