[TheForge] S-7 source

[Jeffrey Polaski]

How do I get free S-7 square stock from a tool rental store? 

I didn't say this before, but I have a few big jackhammer bits. One is a
shovel shape that I use for a hot cut hardy. The other two are typical
spike or spear pint bits. I think they are from a back hoe
concrete-breaker. 

They are quite tough and I was hoping to avoid hammering them down by
hand... I think it would take a couple of hours of fairly heavy work to
get one of those monsters down. I could do it, but I don't have a lot of
time. So I was hoping to get some smaller stock that would be a little
more tractable. 



Jeff Polaski
Research and Graduate Studies Webmaster
University of California, Irvine
http://www.rgs.uci.edu/
949.824.6363

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Dan Tull
Sent: Friday, July 14, 2006 2:12 PM
To: Sponsored by ABANA
Subject: Re: [TheForge] S-7 source

Free from tool rental stores.




OJB!
----- Original Message ----- 
From: "Jeffrey Polaski" <jeff.polaski at rgs.uci.edu>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Friday, July 14, 2006 2:08 PM
Subject: [TheForge] S-7 source


I'd like to get some S-7 to make some few punches out of. I'm looking
for about 1/2" square, or a little larger round or hex stock. Anyone
have a good source?



Jeff Polaski
Research and Graduate Studies Webmaster
University of California, Irvine
http://www.rgs.uci.edu/
949.824.6363


_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________




_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________