[TheForge] S-7 source

[Dan Tull]

Free from tool rental stores.




OJB!
----- Original Message ----- 
From: "Jeffrey Polaski" <jeff.polaski at rgs.uci.edu>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Friday, July 14, 2006 2:08 PM
Subject: [TheForge] S-7 source


I'd like to get some S-7 to make some few punches out of. I'm looking
for about 1/2" square, or a little larger round or hex stock. Anyone
have a good source?



Jeff Polaski
Research and Graduate Studies Webmaster
University of California, Irvine
http://www.rgs.uci.edu/
949.824.6363


_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________