[TheForge] Brooms and Welding Cast

[Washington, Aubrey O.]

BTW, Kenny, I don't have a TIG welder and have never used one.  I just mentioned that because someone else suggested it earlier in this thread.
 
Aubrey

________________________________

From: theforge-bounces at mailman.qth.net on behalf of Kenny O
Sent: Tue 1/3/2006 4:32 PM
To: Sponsored by ABANA
Subject: Re: [TheForge] Brooms and Welding Cast



Washington, Aubrey O. wrote:

>Kenny,
>That's not too much information; I'm always interested in what other people are doing.  I wish I had a buck for every cast iron sideboard socket that I've seen broken just like you describe at antique and junk stores.
>
>If you Google "Welco Kast Weld 111" I'm sure you'll find a dealer somewhere.  I ordered my through Lampton Welding Supply in Oklahoma City.  They got it from one of their other stores (Kansas City, I think) that had a broken 50# package and was willing to sell in small amounts.  I didn't really need 50# of the stuff.  I think the flux was Welco 800, but some other brand might work too.  The rod was $13/lb and the flux was $15 for a 1 lb can, IIRC.
>
>One problem you might run into is heating up that big chunk of cast iron hot enough to weld, without damaging the tubing.  Maybe there is a way to remove it from the brass.  If that's not possible, maybe you could fill the brass tube with water to keep if from melting while you weld.  Do you have a TIG welder?  That might work better than oxy-acet. with a #4 tip (or whatever). In either case, you will have to grind a very deep "V" to get a full penetration weld.  (Just random thoughts.)
>
>Aubrey
> 
>
I appreciate the feedback Aubrey, I will take your advise.
K.O'Loughlin

_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________