HALP !!! Re: [TheForge] Input wanted

[Daniel Kretchmar]

Hey Phlip,
     The picture is the woodcut of an A-frame kitchen that has been passed
around a bit.  In all honesty I don't think the picture would actually work.  I
think it would lean to the side.  My alternative is to put 2 pieces of square
tubing on the legs of opposite A-frames and insert a removable close fitting
1/2 square rod across both frames to keep them from tilting to one side.  The
cross peice rod would have two short verticle sections (2 inch) at the ends and
about a 5 ft long middle section.  The cross piece would fit into the short
pieces of square tubing that you have welded to the each A-frame. I think it
would work but I have yet to try it.

Danr
www.irontreeworks.com
Traditional Woodworking and Blacksmithing


Quoting Phlip <phlip at 99main.com>:

> 
> For reasons known only to Exploder, I can't access the page we're discussing
> :
> 
> ( http://www.oakandacorn.com/hostedimages/cookingrig.jpg )
> 
> Would some kind person please email me the picture? I'm pretty sure I know
> which one you're talking about, and I ought to put it in my Future Projects
> folder anyway, but I want to make sure.
> 
> 
> 
> 
> 
> 
> Saint Phlip,
> CoD
> 
> "When in doubt, heat it up and hit it with a hammer."
>  Blacksmith's credo.
> 
>  If it walks like a duck, and quacks like a duck, it is probably not a
> cat.
> 
> Never a horse that cain't be rode,
> And never a rider who cain't be throwed....
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
>