[TheForge] Who makes a good coal forge

[Phil]

Jerry:

Isn't there a fabrication shop around you that you
could get to make you one?  After all, all we're
talking about is 1/8" sheet steel and angle iron.  You
could even make one yourself without welding buy
drilling and bolting.  I would go with a cast firepot
available from a number of sources on-line.

If you just have to buy one, you're pretty limited. 
Centaur Forge carries them:

http://www.centaurforge.com/

Laurel Machine and Foundry used to:

http://www.lmfco.com/

--- Jerry Smith <jerry_smith at anvilsandinkstudios.com>
wrote:

> I am looking for a coal forge, who out there can
> recommend one for me? This summer would be able to
> fabricate one, but need one sooner, so any ideas? I
> have a new place with no zoning. 
> 
> I know that I should have bought one while I was at
> CanIron IV, have regretted it every since.
> 
> Jerry
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 




		
__________________________________ 
Start your day with Yahoo! - Make it your home page! 
http://www.yahoo.com/r/hs