[TheForge] OT biodiesel

[Jerry Frost]

I use 1" x 8" pipe to a 1 1/4" x 1 1/4" x 1" "T". In a "T" configuration 
rather than a "Sidearm" Jet Ejector.

I recently made a burner for Richard and shortened the mig tip to under 1/2" 
and the 1 1/4" intakes burn too lean, I have to choke them down. I'll remake 
it with a 1" x 1" x 1" "T" and see as soon as I get the new shop up.

There's a poor pic of my burner and Pocket the lap dog (for scale of course, 
it's NOT like I couldn't get her out of the frame. <grin>) under the "forges 
and hoods" folder on Photoaccess.

Robert Grauman was casting iron with a 1 1/4" jet ejector type burner a few 
years back, I doubt he's stopped.

Frosty
------------------------
If it ain't forged
it ain't real.
Wrought iron is.
The FrostWorks

Meadow Lakes, AK.


----- Original Message ----- 
From: <Keporter at aol.com>
To: <theforge at mailman.qth.net>
Sent: Monday, May 30, 2005 9:36 AM
Subject: Re: [TheForge] OT biodiesel


>
> In a message dated 5/30/2005 10:33:37 A.M. Pacific Standard Time,
> frosty at customcpu.com writes:
>
> My  burners are about $9 worth of plumbing, lamp rod, a brass fitting and 
> a
> .045  mig tip.
>
> Frosty
>
>
>
> 1 1/4" or 1 1/2" pipe for their mixing tubes?
> Mike P.
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>